I've been asked to give some more information on this defect and how it
occurred.
First the defect: The solder joints of the effected areas are grainy and
crystalline. Distribution is numerous and random, on the solder side
only. On the component side flow through is great( this is a multi-layer
board with a large ground plane and weird thermal relief that we have
struggle in the past to get decent flow thru). Vias and PTHs without
components are effected as well.
The description of this as an "overheated solder joint" comes not only
frrom my DOD-2000 training (defect code A117) but also the conditions
which produced the "defect."

The conditions: We are using a Novastar 16FD wave solder machine that is
under two years old (we bought it about 3 months ago). We use an RMA
flux and clean the boards by hand with "Reliasol". Preheaters were set
at 430 C (unchanged from previous run of same PWA), but the wave
temperature was raised 250 C to 260 C to address the bridging.

Thanks again for your help.

Tom Moore

Tom Moore wrote:
>
> Technetters,
> In an attempt to reduce solder bridging between P-T-H leads one of
> our employees raised the temperature on the solder pot of our wave
> solder
> machine. While this did alleviate most of the bridging effecting the
> boards,on one board type, a multi-layer board, we ended up with numerous
> overheated joints. Unfortunately it effected 27 boards, which for our
> small shop would be a large amount of rework.
>
> Reviewing both A-610 and J-STD-001 we didn't see anything that called
> this out as a defect to rework or even a process indicator. Is this
> correct?
> Thanks for your help.
> Tom Moore

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
##############################################################