I have just been asked a question about conformal coatings on printed circuit boards
and I can remember this question arising on this forum some time in the past.
I would again like to bring this subject up to try and find out some of the following answers.
The board I wish to apply this coating to is to be used in a high humidity environment
(I) What type of conformal coatings are available ?.
(ii) How easy is it to apply?.
(iii) What will it cost?.
(iv) Is it possible to remove after application for rework etc?.
Thank you
Jim Hedderick
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
##############################################################