I have a million dollar question.
If I plug all non-test vias and encroach soldermask all vias including test
vias on topside then I have a question - how I am going to fill test vias,
as where encroached by solder mask, during wave operation. Bottomside test
vias are not soldermask encroached. In that case any left over contaminant
can be dangerous.
Please reply ASAP your recommendation as I have to release my fab drawing today.
re,
ken patel
______________________________________________________
Ken Patel Phone: (408) 490-6804
575 Cottonwood Dr. Fax: (408) 490-6859
Milpitas, CA 95035 Beeper: (888) 769-1808
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
##############################################################