Gary,

In response to your question:

1) We are doing 100% inspection where time permits.  We inspect all the
specified sites on the board unless the inspection becomes a bottleneck.
Then we use time as the gate.

2) We inspect only fine pitch and BGA pads.  for BGAs we do not use the
bottleneck time-out rule.  If we have pads which have historically been a
problem then we will inspect them as well.

3) We use the SPC format supplied with our machine.

4) Our pass/fail friteria for height is  +2mil/-1.5mil

If you have any other questions feel free to give me a call.  I would like
to know what you think of your new machine.

Greg Parke
Teradyne, Inc.
(617) 422-3192

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
##############################################################