Subject: | |
From: | |
Reply To: | TechNet Mail Forum. |
Date: | Fri, 31 Oct 1997 16:15:49 -0800 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Thanks John. I believe the rule is being broken quite often.
re,
ken patel
At 04:16 PM 10/31/97 -0500, John Nelson wrote:
>We have made boards with plated through holes that are half there and half
missing off the edge of the board. We also make boards with plated edges
nearly all the way around. These get tricky where you have break-away tabs
to hold the board while processing. So I guess there is no rule, or if
there is it is often broken.
>
>----------
>From: Ken Patel[SMTP:[log in to unmask]]
>Sent: Friday, October 31, 1997 3:37 PM
>To: [log in to unmask]
>Subject: [TN] minimum distance a hole can be drilled from the edge
>
>Is there any spec. on drilling a plated hole non-plated hole form the edge,
>I mean, what is the safest minimum distance a hole can be drilled from the
>edge. I believe thickness of the board is a one factor.
>
>##############################################################
>TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
>##############################################################
>To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in the body:
>To subscribe: SUBSCRIBE TECHNET <your full name>
>To unsubscribe: SIGNOFF TECHNET
>##############################################################
>Please visit IPC web site (http://www.ipc.org/html/forum.htm) for
additional information.
>For the technical support contact Dmitriy Sklyar at [log in to unmask] or
847-509-9700 ext.311
>##############################################################
>
>
______________________________________________________
Ken Patel Phone: (408) 490-6804
575 Cottonwood Dr. Fax: (408) 490-6859
Milpitas, CA 95035 Beeper: (888) 769-1808
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
##############################################################
|
|
|