Erik
    The 2 setting that i have changed with good success is the squeegee
speed I lower to about .5 and the squeege wiper I increase to about
every board or every other board. Hope this helps you.
                                                        Mike Lopez


Hi all,

Is is necessary to change the screen printer settings (print speed,
squeege= e = pressure, snap-off speed, etc.) when printing adhesive
relative to the = settings for solder paste printing?  Any information from
your experience in=
 = this area would be appreciated.

Erik Olson
Westell, Inc.

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with
following text in the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for
additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or
847-509-9700 ext.311
##############################################################

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
##############################################################