Subject: | |
From: | |
Reply To: | TechNet Mail Forum. |
Date: | Thu, 23 Oct 1997 14:49:33 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
PCB Fabricators,
My board has the plated finish hole size of 13 mil +0, -8 mil on 93 mil
thick fab and I have the following question in that regards.
(1) Any worry from aspect ratio point of view? or it's a piece of cake for
reliable fab house?
(2) Is current technology is capable of handling this?
(3) What sorts of question should we ask to make sure fab house can do it
meaning from equipment point of view?
Any special comments?
Re,
Ken Patel
______________________________________________________
Ken Patel Phone: (408) 490-6804
575 Cottonwood Dr. Fax: (408) 490-6859
Milpitas, CA 95035 Beeper: (888) 769-1808
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
##############################################################
|
|
|