Does anyone know of any design guides for chip-on-board parts to be used
on FR4 material?
What is minimum trace/spacing capabilities that fab shop can do with this
process?
What about pad sizes for wire bonds?
Via sizes?
Any help and/or where to go would be apprecicated.
Larry L. Pucket
Senior PCB Layout Designer
Sandia National Laboratories
P.O. Box 5800 MS-0624
Albuquerque, NM 87185-0624
Phone: (505)844-1711
Fax: (505)844-7428
Email: [log in to unmask]
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
##############################################################