I have an ongoing arguement with someone. If there is .0018" of annular
ring, are you allowed to "round-up" to .002"? This is based on the fact
that the measuring device resolves to four decimal places but the spec. only
gives three.
I think a minimum is just that, nothing below is acceptable. Your
thoughts..........
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
##############################################################