I've been told that pins can't be reworked because the holes will be
destroyed, then told that small (1 mil) nodules in the holes are the
cause. It's hard to verify, though, because the hole will be
destroyed when the pin is pulled out.
What hole size tolerance would be specified for a high reliability
press fit pin?
Matt Byrne
HADCO
______________________________ Reply Separator _________________________________
Subject: Re: [TECHNET] Press Fit
Author: "TechNet Mail Forum." <[log in to unmask]>, JOHN OSULLIVAN
<[log in to unmask]> at SMTPLINK-HADCO