Before you bring a product to market you must be sure it is ready for
the market place.  Here are a few items to consider.  Have you done
humidity and temperature cycling to test adhesion? Does it qualify to
MIL-I-46058? Can you spray, dip, or brush on for application?  Can it be
reworked?  Does it have good electrical insulating properties? I am not
a marketing expert but I would assume that these questions must be
answered before the product could be widely distributed and sold.
>----------
>
>Gentlemen I have a new technology water borne CONFORMAL coating for printed
>circuit boards. Any suggestions as to how I can take this to market. In
>addition to a clear with detectable dye, I have a black CONFORMAL coating to
>conceal components. Also have an organic dissolver for acrylic, urethane and
>silicon coatings.
>
>Please contact Jim Fraser at 440-729-0450 or fax 440-729-0484 or via email
>[log in to unmask]
>