DESIGNERCOUNCIL Archives

August 1997

DesignerCouncil@IPC.ORG
Options: Use Monospaced Font
Show Text Part by Default
Condense Mail Headers

Message: [<< First] [< Prev] [Next >] [Last >>]
Topic: [<< First] [< Prev] [Next >] [Last >>]
Author: [<< First] [< Prev] [Next >] [Last >>]

Print Reply
Sender:
DesignerCouncil <[log in to unmask]>
X-To:
Rick Wilson <[log in to unmask]>
Date:
Thu, 14 Aug 1997 11:02:35 +0000
Reply-To:
[log in to unmask]
Content-type:
text/plain; charset=US-ASCII
Subject:
Re: Connections from land patterns
From:
JoAnn Amerson <[log in to unmask]>
Content-transfer-encoding:
7BIT
In-Reply-To:
<[log in to unmask]>
MIME-Version:
1.0
Comments:
Authenticated sender is <[log in to unmask]>
Parts/Attachments:
text/plain (15 lines) 
> As I understand it, for solderability reasons the total trace width (one or
> more added togther) should be no more than 1/2 the pad diameter ( I think
> IPC says 60%). Sounds like your engineer just generalized this to one trace
> per pad.
>

What if the pad is a rectangle?  Do I figure the area then base it on 50 to
60%?

JoAnn L. Amerson
Design Librarian
Red Lion Controls, Inc.
E-mail: [log in to unmask]
Voice: (717) 767-6961 ext 6308

ATOM RSS1 RSS2