> Hello,
> Does baking inner layers after oxide conversion, (prior to lay up)
> help in any way? How does it help? How can it hurt? Are some shops
> doing this?
> Thank you,
> Rich
A short bake at low temp. could help. We found water levels of over 1000 ppm
comming off our Oxide line dryer. A 215 F bake for 45 minutes (1"stack)
dropped this to below 300 consistently.
Too much bake will oxidize the copper and lessen adhesion.
Tom Waznis
Hallmark Circuits Inc.
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************