Dear Sir / Madam,

Kindly send  your  competitive quote with techno commercial terms for
following equipment ( supply, fabrication and commissioning )  for drying
or curing of Printed circuit boards.

Technical specifications      :

(a) Description               : Electirically operated Hot air oven

(b) Chamber size ( I.D )      : 1,000 mm (W) x 1,800 mm (H) x 900 mm (H)

(c) Working temperature       : Up to 200 Deg. C ( +/- 2 Deg.C )

(d) Heating elements          : "U" Type tubular heater
				( Elpro / Recold / Escorts make )

(e) Hot air circulation       : By motor driven centrifugal fan - 1 Nos
				Mils steel material construction
				Fan capacity motor : 5 H.P
				( Make : NGEF / Kirloskar / ABB  Motor )

(f) Temp. Control             : Automatic through temperature controller
			        at any temp. in the working rage of 40 Deg
				to 200 Deg. C.

(g) Safety thermostat         : To switch off the supply to heating
			        elements at a temp. 10 Deg.C. above the
			        setting of temp. controller, as a
				safeguard against failure of temp. controller.
 
(h) Interlocking system       : 1.  Between motor and heating elements
				2.  Between door closing & fan motor

(i) Door lock                 : Single door at front aided with		
				arrangement locking	

(j) Insulation                : Epoxy bonded mineral wool 150 mm thick

(k) Control panel             : Wall mounted, provided with incoming
				isolator, MCB's, over load relay for fan, 
				contactors for fan and heaters,indicating lamps
			        ON / OFF push buttons, and controllers and
				timers.

(l) Input power supply        : 415 Volts, 3 phase, 50 Hz, AC - wire

If you require any additional informataions regarding this matter, please
contact immediately.

Regards


H.N.MURALIDHARA,
M/s Indal Electronics Limited, Nanjangud
PHONE No.: 91-8221-26584/26618/26619
FAX      : 91-8221-26641
E-MAIL   : [log in to unmask]
WEB      : http://www.indalpcb.com



***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]>   *
* with <subject: subscribe/unsubscribe> and no text in the body.          *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact   *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask]      *
***************************************************************************