 
| Received: |
by ipc.org (Smail3.1.28.1 #2)
id m0wrqm8-000BkqC; Fri, 25 Jul 97 15:15 CDT |
| Content-Type: |
TEXT/PLAIN; charset=US-ASCII |
| Old-Return-Path: |
|
| Date: |
Fri, 25 Jul 1997 16:26:09 +0400 (EDT) |
| Precedence: |
list |
| From [log in to unmask] Mon Jul 28 09: |
45:09 1997 |
| Resent-Sender: |
|
| MIME-Version: |
1.0 |
| >From willli Fri Jul 25 15: |
16:06 1997 |
| X-Mailing-List: |
|
| TO: |
|
| Return-Path: |
<TechNet-request> |
| X-Status: |
|
| Status: |
O |
| X-Loop: |
|
| Resent-Message-ID: |
<"vlw7m3.0.-LB.lbGsp"@ipc> |
| Subject: |
|
| From: |
|
| Resent-From: |
|
| In-Reply-To: |
|
| cc: |
|
| Message-ID: |
|
| Parts/Attachments: |
|
|
Just remember you always get what you pay for!! You might be saving money
in the short run bu it will cost you in the long run.
.
On Fri, 25 Jul 1997, Jack Olson wrote:
> Trivial question, but to the fabricators out there:
> What percentage of your customers faithfully supply
> targets on the Gerber data?
> Do you even use targets for alignment or measuring?
>
> Also, for anyone who cares to comment:
> At my new company we are using vendors who can't
> plot their own film, and we have to modem the data
> over to a photoplotting vendor. This implies that
> NO up-front engineering type CAM work is being done,
> and most of these boards are impedance controlled
> RF designs. Am I confused in thinking maybe we should
> look for more modernized vendors, or did I just get
> spoiled by cream-of-the-crop high-tech excellence?
> (Also, its probably worth noting that the previous
> employer's concern was high-quality prototypes FAST
> TURN no matter the cost. Whereas here, money is a big
> issue and these low-tech places are CHEAP!)
>
> Not trying to start any wars here, but I'm curious
> how many vendors these days just work from someone
> else's film?
>
> ***************************************************************************
> * TechNet mail list is provided as a service by IPC using SmartList v3.05 *
> ***************************************************************************
> * To subscribe/unsubscribe send a message <to: [log in to unmask]> *
> * with <subject: subscribe/unsubscribe> and no text in the body. *
> ***************************************************************************
> * If you are having a problem with the IPC TechNet forum please contact *
> * Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
> ***************************************************************************
>
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
|
|
|
