>From willli Tue Jul 22 11: |
03:58 1997 |
Old-Return-Path: |
|
Date: |
Tue, 22 Jul 97 07:40:02 PST |
Precedence: |
list |
Resent-From: |
|
Resent-Sender: |
|
X-Status: |
|
Status: |
O |
X-Mailing-List: |
|
TO: |
|
Return-Path: |
<TechNet-request> |
Resent-Message-ID: |
<"QnSSV1.0.RGD.adDrp"@ipc> |
Subject: |
|
From: |
|
Received: |
by ipc.org (Smail3.1.28.1 #2)
id m0wqhPh-000BjpC; Tue, 22 Jul 97 11:03 CDT |
X-Loop: |
|
From [log in to unmask] Thu Jul 24 18: |
19:41 1997 |
Message-Id: |
|
Parts/Attachments: |
|
|
The smaller grain size will definitely do both for you. Small grain copper
etches faster, the side walls of the traces are cleaner and the etch factor is
lower. Looking at the traces under the scope you should see the difference with
no difficulty. The smaller grains are also closer so there is less porosity and
higher flexibility.
Good Luck and have fun.
Chuck Brummer
Acuson
______________________________ Reply Separator _________________________________
Subject: Cu Foil Grain size
Author: [log in to unmask] at ccUnix
Date: 7/22/97 12:53 AM
Hi,
Does anyone know how would the grain size of the matt surface of the Cu
foil (say 1/2 oz)
affect the etching performance, peel strength and any other properties of
the PCB?
The reason is we have a Cu foil supplied from Japan with very fine grain
nodules < 1um.
Then another from Korea with larger grain at the matte surface (1 - 2um)
under the SEM.
Smooth side for this Korean foil is also rougher.
I read one article from the Japan supplier that the smaller the grain the
faster the etching rate, thus easier and better etching especially for
fine-lines.
Any Comment?
Richard
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
|
|
|