Subject: | |
From: | |
Date: | Sat, 12 Jul 1997 15:03:11 +0530 (IST) |
Content-Type: | TEXT/PLAIN |
Parts/Attachments: |
|
|
Dear Sir / Madam,
Kindly send your competitive quote with techno commercial terms for
following equipment ( supply, fabrication and commissioning ) for drying
or curing of Printed circuit boards.
Technical specifications :
(a) Description : Electirically operated Hot air oven
(b) Chamber size ( I.D ) : 1,000 mm (W) x 1,800 mm (H) x 900 mm (H)
(c) Working temperature : Up to 200 Deg. C ( +/- 2 Deg.C )
(d) Heating elements : "U" Type tubular heater
( Elpro / Recold / Escorts make )
(e) Hot air circulation : By motor driven centrifugal fan - 1 Nos
Mils steel material construction
Fan capacity motor : 5 H.P
( Make : NGEF / Kirloskar / ABB Motor )
(f) Temp. Control : Automatic through temperature controller
at any temp. in the working rage of 40 Deg
to 200 Deg. C.
(g) Safety thermostat : To switch off the supply to heating
elements at a temp. 10 Deg.C. above the
setting of temp. controller, as a
safeguard against failure of temp. controller.
(h) Interlocking system : 1. Between motor and heating elements
2. Between door closing & fan motor
(i) Door lock : Single door at front aided with
arrangement locking
(j) Insulation : Epoxy bonded mineral wool 150 mm thick
(k) Control panel : Wall mounted, provided with incoming
isolator, MCB's, over load relay for fan,
contactors for fan and heaters,indicating lamps
ON / OFF push buttons, and controllers and
timers.
(l) Input power supply : 415 Volts, 3 phase, 50 Hz, AC - wire
If you require any additional informataions regarding this matter, please
contact immediately.
Regards
H.N.MURALIDHARA,
M/s Indal Electronics Limited, Nanjangud
PHONE No.: 91-8221-26584/26618/26619
FAX : 91-8221-26641
E-MAIL : [log in to unmask]
WEB : http://www.indalpcb.com
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
|
|
|