 
| Received: |
by ipc.org (Smail3.1.28.1 #2)
id m0wZzzM-000BjGC; Fri, 6 Jun 97 09:27 CDT |
| Encoding: |
40 TEXT |
| Old-Return-Path: |
|
| Date: |
Fri, 06 Jun 97 09:33:00 PDT |
| Precedence: |
list |
| Resent-From: |
|
| Resent-Sender: |
|
| X-Status: |
|
| >From willli Fri Jun 6 09: |
27:57 1997 |
| X-Mailing-List: |
|
| From [log in to unmask] Fri Jun 6 09: |
38:55 1997 |
| TO: |
|
| Return-Path: |
<TechNet-request> |
| Resent-Message-ID: |
<"069VB3.0.UjH.Nv1cp"@ipc> |
| Subject: |
|
| From: |
|
| Status: |
O |
| X-Loop: |
|
| X-Mailer: |
Microsoft Mail V3.0 |
| Message-Id: |
|
| Parts/Attachments: |
|
|
I personally, am having a hard time visualizing this question. Please
expound.
----------
From: TechNet-request
To: technet
Subject: double sided reflow-soldering top side to bottom side parts.
Date: Friday, June 06, 1997 8:52AM
I have an application where I need to reflow solder a part on the top
side of a double sided SMD board through the board to a bottom side
component without plating the hole.
This part is large and is placed within a slot in the panel. It must
physically touch the part on the bottom side.
Does anyone have any suggestions on screen printing this,
The stencil aperture will not contact the PCB surface where I need to
put the paste, but will be over a slot in the PCB.
Thanks for any help,
Aric
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
|
|
|
