Hi,
You wrote once in Technet :
Is there a rule-of-thumb when designing paste aperture sizes for
non-standard pad sizes. I'm thinking about a copper area vs stencil
opening area ratio for SMT.
__________________________________
Scott Buscomb
[log in to unmask]
voice 770 338-6170
MTCC/Panasonic, Pager Development
Atlanta, GA USA 30174
__________________________________
Did you get any replies ? If you got any, please forward them to me.
Thanks in advance for your cooperation.
Brs, [log in to unmask]
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************