TECHNET Archives

May 1997

TechNet@IPC.ORG

Options: Use Monospaced Font
Show Text Part by Default
Show All Mail Headers

Message: [<< First] [< Prev] [Next >] [Last >>]
Topic: [<< First] [< Prev] [Next >] [Last >>]
Author: [<< First] [< Prev] [Next >] [Last >>]

Print Reply
Subject:
From:
sam mccorkel <[log in to unmask]>
Date:
Wed, 21 May 1997 15:23:53 -0400
Content-Type:
text/plain
Parts/Attachments:
text/plain (20 lines)
We're having problems with "solder balls" that are "resting in a nest". We
have .025" via holes that are covered with L.P.I. soldermask. The mask is
collapsing when going through our vertical hot air leveler and little
"solder balls" are sitting just inside the holes. The solder balls are
falling out at subsequent operations and in some cases are ending up between
contact fingers that have .006" spacing between. The solder balls are
creating a short at electrical test. They are easily removed but not easily
detected before hand. Any ideas on what we can do to eliminate this problem?

***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]>   *
* with <subject: subscribe/unsubscribe> and no text in the body.          *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact   *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask]      *
***************************************************************************


ATOM RSS1 RSS2