I was given a project to investigate new bar code technology. The reason is
we currently have to reserve too much keep out area for bar code labels:
all PCBA's require Qty 2 keep out areas 7mm x 33 mm for labels. This is
becoming very difficult for high-density PCBAs. We need to come up with
smaller labels to fit into smaller keep out areas. I like to know any
information helpful including
New label materials
New equipement
New methods (bar coding the side/edge of the board)
etc.
Appreciate any help.
Yuan Li, Ph.D.
SMT Engineer
Exabyte, (303)417-5655, 417-7130 (fax)
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************