Subject: | |
From: | |
Date: | Fri, 23 May 97 07:31:00 PDT |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
To the person with the solder balls on assembly boards if you contact me
at [log in to unmask] I can help you with the problem.
----------
From: TechNet-request[SMTP:[log in to unmask]]
Sent: Thursday, May 22, 1997 6:05 AM
To: TechNet
Subject: Re: Solder balls
Do the via plug after Hot Air Solder Leveling. That should
eliminate
the problem.
______________________________ Reply Separator
_________________________________
Subject: Solder balls
Author: [log in to unmask] at corp
Date: 5/21/97 12:34 PM
We're having problems with "solder balls" that are "resting in a nest".
We
have .025" via holes that are covered with L.P.I. soldermask. The mask is
collapsing when going through our vertical hot air leveler and little
"solder balls" are sitting just inside the holes. The solder balls are
falling out at subsequent operations and in some cases are ending up
between
contact fingers that have .006" spacing between. The solder balls are
creating a short at electrical test. They are easily removed but not
easily
detected before hand. Any ideas on what we can do to eliminate this
problem?
**************************************************************************
*
* TechNet mail list is provided as a service by IPC using SmartList v3.05
*
**************************************************************************
*
* To subscribe/unsubscribe send a message <to: [log in to unmask]>
*
* with <subject: subscribe/unsubscribe> and no text in the body.
*
**************************************************************************
*
* If you are having a problem with the IPC TechNet forum please contact
*
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask]
*
**************************************************************************
*
**************************************************************************
*
* TechNet mail list is provided as a service by IPC using SmartList v3.05
*
**************************************************************************
*
* To subscribe/unsubscribe send a message <to: [log in to unmask]>
*
* with <subject: subscribe/unsubscribe> and no text in the body.
*
**************************************************************************
*
* If you are having a problem with the IPC TechNet forum please contact
*
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask]
*
**************************************************************************
*
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
|
|
|