Hi Technetters:
        
        I am investigating an improvement to the ink stamping process
 used in our facility.  We currently mark pwbs with a two part epoxy ink
 and an oven cure.  I was hoping you could offer some information on
marking pwbs using UV ink that meets MIL-P-55110 or MIL-STD-130 requirements,
 or any other process improvement that we could implement.
        We are a small volume pwb facility and your comments would be
appreciated.
        
        Thank you
        Bob Dewlin
Modular Components National, Inc.
2302 Industry Court
Forest Hill, MD 2150
PH (410) 879-6553
Fax (410) 838-7629

***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]>   *
* with <subject: subscribe/unsubscribe> and no text in the body.          *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact   *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask]      *
***************************************************************************