Jim..
Thanks for the reply and I will review the 610 spec. However, your
last sentence is the crux of my problem.....I DON'T KNOW what should be
on the drawing. I was hoping that someone that design/manuf test set
hardware could tell me what is acceptable in the real world. Thanks for
your imput and I will review the 610 spec.
Regards,
Bob
Bob Vanech
Norden Systems
(203) 852-4810
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************