Elizabeth:
What is your conveyor speed and conveyor angle? What type of machine
do you have? Surface tension/peel off upon exit from the wave is
usually critical. Is your flux and mask compatible? What is the
purity level of your solder? Have you tried changing the board
orientation as it goes through the wave?
With no-clean flux conveyor speeds could reach six feet per minute.
Normal conveyor angle is usually around seven degrees. The above
questions are some things you may want to check as far as your setups
and process.
[log in to unmask]
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************