Subject: | |
From: | |
Date: | Fri, 11 Apr 97 10:39:41 PDT |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Check out IPC-TM-650, Method 2.4.8. It lists the required angle,
rate, and measurement method to use. All of which have an influence over the
results. Also, Section 5.8.3 has a test pattern that you can use.
To get the peel started, I always used an Exacto-Knife to lift the
copper foil off the laminate. Be extremely careful though. My other hand was
always wearing the thickest leather glove I could get by with for fear of
sharp blade slicing my hand.
Glenn Pelkey
Quality/Reliability Engineer
Maxtek Components Corp.
[log in to unmask] (Dave Malanchuk) Wrote:
|
| How does one test for the copper peel strength on standard
| PWB?
| How does one start the peel of the copper so that it can
| be pulled
| with an Instron, etc.?
|
| David Malanchuk (716) 726-4843
| Electronic Products
| Kodak Equipment Manufacturing Division
| Rochester, NY
| [log in to unmask]
|
| **********************************************************
| *****************
| * TechNet mail list is provided as a service by IPC using
| SmartList v3.05 *
| **********************************************************
| *****************
| * To subscribe/unsubscribe send a message <to:
| [log in to unmask]> *
| * with <subject: subscribe/unsubscribe> and no text in the
| body. *
| **********************************************************
| *****************
| * If you are having a problem with the IPC TechNet forum
| please contact *
| * Dmitriy Sklyar at 847-509-9700 ext. 311 or email at
| [log in to unmask] *
| **********************************************************
| *****************
|
|
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
|
|
|