I received some mix technologies assemblies that have a great deal of bow
and twist in them.
In reading IPC-610-B, sec. 8.3: it states that .75% is the maximum amount
allowed.
The question that I have is the measurement made diagonal or across one of
the edges?
Thanks,
Scott
***************************************************************************
Scott Priore Phone: 408-527-1814
Supply Base Engineer - Core Fax: 408-526-5265
Cisco Systems, Inc. Pager: 800-796-7363 / PIN 100-3236
***************************************************************************
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************