Subject: | |
From: | |
Date: | Wed, 26 Mar 1997 05:24:16 +0800 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
From: Scott Westheimer
Date:3/26/97
A couple of weeks ago I sent out an e-mail looking for some information on
riveting, but unfortunately did not receive any responses. In a hope to get
some information I would like to resubmit my inquiry and this time ask more
direct questions.
What height of rivet, before riveting, do most people use for panels that
are 0.018" to 0.062"?
Can you use the same rivet for the different thickness?
What height should the rivet be after riveting the panels?
What type of gap do you set on your rivet machines?
Do you use different gap settings for different thickness' of panels?
Any suggestions or answers would be appreciated.
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
|
|
|