Subject: | |
From: | |
Date: | Mon, 10 Mar 1997 09:46:46 +0800 (HKT) |
Content-Type: | TEXT/PLAIN |
Parts/Attachments: |
|
|
Dear all,
I am trying to gather some industrial experiences on the double sided
reflow soldering. Please take a minute or two to fill up the following
questionaire. After compiling the results, I am willing to share the final
results to those of you who respond to it.
Would you care to reply, please send to [log in to unmask]
Thank you very much.
Best regards,
Victor
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
Questionaire for double sided reflow soldering
==============================================
Type of oven used : ( ) IR conventional
( ) Forced Air
( ) Forced Air with Nitrogen
( ) Others, pls. specify _____________
Brand Name of the oven : ______________________
How often does your shop floor perform double sided reflow process?
( ) 75 % of the time, or above
( ) 50 < x < 75 % of the time
( ) 25 < x < 50 % of the time
( ) less than 25 % of the time
What is the length of the PCB commonly used in double sided reflow process?
( ) 200 mm or above
( ) 100 < x < 200 mm
( ) 100 mm or less
Which connecting medium do you use in the double sided reflow process?
( ) conductive adhesive + solder paste (melting pt. 183 C)
( ) the same kind of solder paste
( ) high temp. solder paste + solder paste (melting pt. 183 C)
( ) low temp. solder paste + solder paste (melting pt. 183 C)
( ) Others : ____________________________________________________
____________________________________________________
Do you find this process difficult to control? Why?
____________________________________________________________________________
____________________________________________________________________________
____________________________________________________________________________
When doing the second pass, how often did the components on the bottom side
fall off?
( ) 1. Never happen
( ) 2. 0 < x < 20% of the time
( ) 3. 20< x < 40% of the time
( ) 4. 40< x < 60% of the time
( ) 5. 60< x < 80% of the time
( ) 6. 80% or above
If you answer 2. to 6. please list the components which caused problems :
( ) BGA, # of pins : _____ Size: _____ mm x _____ mm
( ) PLCC # of pins : _____ Size: _____ mm x _____ mm
( ) QFP # of pins : _____ Size: _____ mm x _____ mm
( ) Others(Pls. specify) : Type _______ # of pins _____ Size: ____mm x ____mm
: Type _______ # of pins _____ Size: ____mm x ____mm
What might be the suspected reasons for the fallen components?
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
Thank you very much for your time.
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
|
|
|