Received: |
by ipc.org (Smail3.1.28.1 #2)
id m0w9fqp-000BjNC; Tue, 25 Mar 97 17:41 CST |
Old-Return-Path: |
|
Date: |
Tue, 25 Mar 97 15:42:10 PST |
From [log in to unmask] Wed Mar 26 08: |
34:24 1997 |
Precedence: |
list |
Resent-From: |
|
Resent-Sender: |
|
X-Status: |
|
Status: |
O |
X-Mailing-List: |
|
TO: |
|
Return-Path: |
<TechNet-request> |
Resent-Message-ID: |
<"lSH4x.0.D9K.6B6Ep"@ipc> |
Subject: |
|
From: |
|
X-Loop: |
|
Cc: |
|
Message-Id: |
|
Parts/Attachments: |
|
|
Scott,
Sorry, I don't even remember getting your first message.
In a previous life as a mass laminator we used rivets to hold two inner layer
cores together. Tooling holes had been precisly punched and we sandwhiched the
inner cores around pre preg. It worked pretty well.
Problems we encountered had to do with listing or breaking. We use a two piece
rivet sized for the package they had to hold.
Good luck.
Chuck Brummer
Acuson
______________________________ Reply Separator _________________________________
Subject: LAMINATION RIVETING
Author: [log in to unmask] at ccUnix
Date: 3/25/97 3:36 PM
From: Scott Westheimer
Date:3/26/97
A couple of weeks ago I sent out an e-mail looking for some information on
riveting, but unfortunately did not receive any responses. In a hope to get
some information I would like to resubmit my inquiry and this time ask more
direct questions.
What height of rivet, before riveting, do most people use for panels that
are 0.018" to 0.062"?
Can you use the same rivet for the different thickness?
What height should the rivet be after riveting the panels?
What type of gap do you set on your rivet machines?
Do you use different gap settings for different thickness' of panels?
Any suggestions or answers would be appreciated.
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
|
|
|