Subject: | |
From: | |
Date: | Tue, 28 Jan 1997 14:51:13 +600 CDT |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
We would like to receive input on the positive and negative aspects
of horizontal etching with oscillating spray bars, versus vertical
etching of inner layers and outer layers using an alkaline etchant.
We would like to hear of experiences as to which method provides
the best results in terms of line width uniformity, top to bottom
consistency, and conveying of cores as thin as .004 with half ounce
copper on both sides.
Panel sizes vary from 12 X 12 to 21 X 30. Line and spaces down to
.004 X .004 for the smaller panels, .008 X .008 on the larger panels.
Please presume that equipment of either type is well maintained and
that the chemistry is under good control.
Many thanks,
Luis Rivera
CompuRoute, Inc.
Dallas, TX
[log in to unmask]
(214) 340-0543
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
|
|
|