sam mccorkel wrote:
>
> I'm looking for any cautions or advice you may have on the following.
> We are considering the use of immersion tin as a finish on bare printed
> circuit boards.
> The boards are thru-hole only and they will be wave soldered within the next
> 3-4 weeks.
> Do you consider this a "no no" or is this an acceptable finish until wave
> soldering?
>
> ***************************************************************************
> * TechNet mail list is provided as a service by IPC using SmartList v3.05 *
> ***************************************************************************
> * To unsubscribe from this list at any time, send a message to: *
> * [log in to unmask] with <subject: unsubscribe> and no text. *
> ***************************************************************************
> * If you are having a problem with the IPC TechNet forum please contact *
> * Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
> ***************************************************************************
Do not use TIN coatings on PCB. Have you not read about Tin-Whisker
growth on tin coated boards that cause random short failures.
This mechanism has ben documented in several papers. Recently, a few
emails have beeen posted about the same mechanism.
--
Pratap Singh
Tel./Fax: 512-255-6820
e-mail: [log in to unmask]
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************