Hi Technetters,

I would like to comment you, that it's really difficult to solder with a low
residual fluxes at temperatures lower that 90ºC.

Usually we reccomend to use temperatures arround 120ºC in the bottom of the
heated face of PCB.

If you don't get the required results, may be possible that you are not
giving the required temperature. In this case you can try need reducing your
conveyor speed.

best regards.
                          =================================
                          =         TONI CHERTA           =
                          = E-mail: [log in to unmask]   =
                          =   Fax: +34.3.274.00.80        =
                          =            SPAIN              =
                          =================================

***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to:           *
* [log in to unmask] with <subject: unsubscribe> and no text.        *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact   *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask]      *
***************************************************************************