Nick
IPC-D-275 states that the clear area should be no less than 0.010 inch. This
number takes into account the difficulties in etching and the subsequent
inspection of a large copper plane.
This requirement meets general board manufacturing capabilities . However,
you may be able to find some specialized fabricators that can do better.
Regards,
Gary Ferrari
IPC Staff
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************