Subject: | |
From: | |
Date: | Thu, 9 Jan 1997 17:21:30 GMT |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
To : Steve O'Hara / Technet group
Our current supplier that we have been using in the past to supply Ag
Polymer boards are
CMK (NV)
Nijverheidsstraat 18,
2260 Westerlo-Oevel,
Belgium
Contact : Mark Cornellis
They were/are manufacturing in Japan but are moveing the technology to
Belgium shortly.
Without meaning to advertise on their behalf, I must say that we have
had no problems with the supplied products and the quality was of a
very high standard.
Although they have supplied me with design layout guidelines with
regard to this technology I would appreciate any information which we
can use measure the quality of the polymer holes. If this is
contained in the Hokuriku booK then this would be most appreciated.
regards
Lee Dunford
ECAD Supervisor
Pace Micro Technology
Victoria Road
Saltaire
Shipley
West Yorkshire
UK
(0)1274 532000
Email: [log in to unmask]
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
|
|
|