 
| Received: |
by ipc.org (Smail3.1.28.1 #2)
id m0uA2vz-00004HC; Thu, 18 Apr 96 18:16 CDT |
| Old-Return-Path: |
|
| Date: |
Thu, 18 Apr 1996 19:07:05 -0500 |
| Precedence: |
list |
| Resent-From: |
|
| Resent-Sender: |
|
| X-Status: |
|
| Status: |
O |
| X-Mailing-List: |
|
| TO: |
|
| Return-Path: |
<TechNet-request> |
| Resent-Message-ID: |
<"el2KY.0.YSE.2riTn"@ipc> |
| Subject: |
|
| From: |
|
| From [log in to unmask] Sat Apr 27 16: |
04:04 1996 |
| X-Loop: |
|
| Message-Id: |
|
| Parts/Attachments: |
|
|
Typically, what is the minimum spacing between printed circuit solder
pads that would allow for enough LPI soldermask to prevent bridging
for a wave soldering process ?
Is there a design guideline that specifically addresses this ? If so,
can you point me in the right direction.
Any assistance would be greatly appreciated.
Thanks
|
|
|
