[log in to unmask][log in to unmask] > > IPC-D-275 figure 4-9 states to ocmes out from the component body 2 diameters but not less than 0.03 inch. to the biginning of the bend raduis. The bend raduis is determined by the lead diameter. up to 0.030 inch, R = 0.030. From 0.030 to 0.047 inch, [...][log in to unmask]
Small Silicon Valley PCB design bureau is seeking a highly
motivated individual with entrepreneurial spirit. There is an
ownership or partnership opportunity for the right individual.
9 to 5ers need not apply.
For further information contact [log in to unmask]
****************************************************************************
* The mail list is provided as a service by IPC using SmartList v3.05 *
****************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
****************************************************************************