Subject: | |
From: | |
Date: | Fri, 19 Apr 96 07:10:56 EST |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
In our designs we use .005" spacing for LPI solder mask and have had
very good success. Most PCB manufacturer would be willing to set up a
minimum standard per their process.
______________________________ Reply Separator _________________________________
Subject: FAB:ASSY:pad spacing
Author: [log in to unmask] at SMTPpost1
Date: 4/18/96 9:03 PM
Typically, what is the minimum spacing between printed circuit solder
pads that would allow for enough LPI soldermask to prevent bridging
for a wave soldering process ?
Is there a design guideline that specifically addresses this ? If so,
can you point me in the right direction.
Any assistance would be greatly appreciated.
Thanks
|
|
|