The following question is one that was provided by designers for
the A basic level exam. It is NOT included in the final published
test and is for reference only. The topic is Copper Features..
*************************************************************
107 How many component leads can be mounted in any one hole
used for attaching the component to the circuit pattern?
A. one lead
B. no more than two leads
C. no more than three leads
D. no more than four leads
select the most correct answer
*********************************************************
Previous QOD
106 Proper tooling hole systems consist of a certain number
of holes which are positioned in certain locations on the
board. What are their characteristics?
D. a specific number and location to facilitate the
assembly operation
Resource: IPC-T-50 Specific Terms and IPC-D-275 para 3.3.5;
6.5; table 6.2
*********************************************************
Please send comments, constructive critique, or suggestions to Lisa
Williams at [log in to unmask]
Dieter Bergman