Subject: | |
From: | |
Reply To: | |
Date: | Fri, 15 Nov 1996 10:28:21 -0800 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
My question to fellow TechNetters is:
What are some typical Ionic Contamination Levels seen at Pre-Soldermask
application and Final levels of bare board before shipping?
Do other end users require monitoring of Pre-Soldermask levels of Ionic
Contamination or just at final?
We are currently going to specify 10 micro grams/sq" does anyone else
specify anything tighter? Is there a cost associated at the boasrd level
to spec something tighter.
Steve Collins
PCB Design Supervisor
TSX Corporation
El Paso, TX
Ph: (800) 351-2345
Fax: (915) 543-4898
email: [log in to unmask]
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
|
|
|