> 
>      We recently began that process using custom pallets with integral

>      shields. 
>      
>      We run the entire assembly a the same wave height. The only major

>      insufficients that remain are due to shields masking some pads.
This 
>      can be eliminated by rotating the panel.
>      
>      Aric Parr
>      [log in to unmask]
> 
> 
Hi Aric.

The problem i get when have the same wave height all over the board is
dewetting mostly on pth ICs and similar. Maybe the wave is too high? But
then, if i lower it, the shields won't get soldered all over. The
problem we have is that the shield has to be "gas-impenetrable"

***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to:           *
* [log in to unmask] with <subject: unsubscribe> and no text.        *
***************************************************************************