Subject: | |
From: | |
Date: | Tue, 30 Jul 1996 08:41:53 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Dave,
It is common practice for us to use array's with x-out boards. We
normally have the fiducial marked to allow the machine to skip that
board.
Pro's: cost reduction from the vendor
Con's: increases cycle time
tighter material control
I hope this helps......
[log in to unmask]
Jabil Circuits Inc.
Worldwide Project Engineer
______________________________ Reply Separator _________________________________
Subject: X-outs on panels
Author: "King; Dave" <[log in to unmask]> at IE_StPeteB1
Date: 7/29/96 2:34 PM
We buy boards in panel form and do not allow any x-outs. Occasionally we
have discussions about allowing x-outs and the potential cost savings by
doing so.
Does anyone have any comments on the pros & cons of allowing x-outs?
Dave King
[log in to unmask]
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
|
|
|