Received: |
by ipc.org (Smail3.1.28.1 #2)
id m0tz1LT-00006YC; Tue, 19 Mar 96 07:21 CST |
Content-Type: |
TEXT/PLAIN; charset=US-ASCII |
Old-Return-Path: |
|
Date: |
Tue, 19 Mar 1996 08:25:45 +0500 (EST) |
Precedence: |
list |
Resent-From: |
|
Message-ID: |
|
MIME-Version: |
1.0 |
Status: |
O |
X-Mailing-List: |
|
TO: |
|
Return-Path: |
<TechNet-request> |
Resent-Message-ID: |
<"B7niz.0.OWC.-IhJn"@ipc> |
Subject: |
|
From: |
|
X-Status: |
|
From [log in to unmask] Wed Mar 20 14: |
58:06 1996 |
X-Loop: |
|
Resent-Sender: |
|
Parts/Attachments: |
|
|
Last week I asked for comments on our post-HASL cleaning process. As
suggested when the forum started operation, I am offering a summary of
input I received from several sources.
Our process, in brief, consists of two water sprays, dip in a flux
remover, dip in a heated flowing water rinse, and a final water spray.
Fellow forum participants submitted the following:
- our process is fairly standard, may consider eliminating the flowing rinse
- conveyorized hot water blaster with Cascade dish detergent and gentle
nylon brushes works well
- nylon brush in recirculating rinse module with Cascade dish detergent,
followed by rinse and dry, produced clean and good-looking boards; water
hardness may affect results
- mild soap with rinse and dry is one method; more information is on the way
- "call me for more information"; haven't been able to get in touch yet.
The "Cascade" solution reminds me of something I read in the IEEE
SPectrum a year or so ago. Regarding "green" technologies, I believe
some people at Sandia or Lawrence Livermore or some such place found the
best way to clean PC assemblies was to put them in a dishwasher with a
little detergent and a dose of lemon juice.
Lou Hart
.
|
|
|