Mime-Version: |
1.0 |
Content-Type: |
text/plain; charset=US-ASCII; name="Re:" |
Old-Return-Path: |
|
Date: |
Thu, 12 Dec 96 11:20:24 +0100 |
From [log in to unmask] Thu Dec 12 15: |
58:12 1996 |
Precedence: |
list |
Resent-From: |
|
Resent-Sender: |
|
Content-Transfer-Encoding: |
7bit |
Status: |
O |
X-Mailing-List: |
|
TO: |
|
Return-Path: |
<TechNet-request> |
X-Status: |
|
X-Loop: |
|
Resent-Message-ID: |
<"TqA7e.0.Ru9.avzho"@ipc> |
Subject: |
|
From: |
|
Received: |
by ipc.org (Smail3.1.28.1 #2)
id m0vY8No-0000QBC; Thu, 12 Dec 96 04:28 CST |
X-Openmail-Hops: |
1 |
In-Reply-To: |
|
Message-Id: |
<H000048500aab856@MHS> |
Parts/Attachments: |
|
|
> Tom:
>
> If you are using no-clean flux to solder SOTs (or anything with tall,
> non-solderable body that will repel the wave from reaching the pad,
such as
> tantalum capacitors), dual wave would not work. This is because the
first
> wave (chip or turbulant wave) will kill the flux, resulting in the
poor
> solderability at the second wave (lambda wave). The way we do it
rather
> successfully is to elongate the pad size and solder them with a
vibrating
> wave (omega wave), which has much lower surface energy to reach any
shadowed
> pads. Good luck.
>
> Regards
> Jauwhei Hong
> [log in to unmask]
Jauwhei Hong,
We don't have any problems soldering SOT's with no-clean flux and
dual-wave (chip & lambda). We get fine results if we only use an angle
of 4 degrees, accurate dwell time for the specific pcb and a "perfect"
preheat profile. We also don't have to elongate the pad sizes, we use
the ordinary sizes the pick & place do.
i don't know, but are we different?
/Jan Merstrand
Operation Engineer
Ericsson Microwave Systems
[log in to unmask]
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
|
|
|