Received: |
by ipc.org (Smail3.1.28.1 #2)
id m0vKv1w-0000ZqC; Tue, 5 Nov 96 17:35 CST |
Content-Type: |
TEXT/PLAIN; CHARSET=US-ASCII |
Old-Return-Path: |
|
Date: |
Tue, 5 Nov 1996 15:43:54 -0800 |
Precedence: |
list |
Reply-To: |
|
cc: |
|
MIME-Version: |
1.0 |
Status: |
O |
From [log in to unmask] Wed Nov 6 08: |
45:48 1996 |
TO: |
|
Return-Path: |
<TechNet-request> |
X-Status: |
|
X-Loop: |
|
X-Mailing-List: |
|
Resent-Message-ID: |
<"7lIZW3.0.SbA.BzyVo"@ipc> |
Subject: |
|
From: |
|
Resent-From: |
|
Priority: |
Normal |
Resent-Sender: |
|
Message-Id: |
|
Parts/Attachments: |
|
|
Jim: Try Loctite's Output seies.It's a one component syringe
dispensable thixotropic system good to 300 F.Fixture time is
about 5 mins. however it does require an activator.
Loctite 1-800-562-8483
Regards
Michael Barmuta
Staff Engineer
Fluke Corp.
Everett Wa.
(206)356-6076
On Tue, 5 Nov 1996 11:33:00 -0800 JIM ENNIS wrote:
> From: JIM ENNIS <[log in to unmask]>
> Date: Tue, 5 Nov 1996 11:33:00 -0800
> Subject: Assy: Thermally Conductive Adhesive
> To: TechNet <[log in to unmask]>
>
>
> Question: I need a thermally conductive adhesive to put under a QFP. I
> know that if I put it on prior to placement, it would screw up my
alignment,
> soldering, etc, I plan to add a hole (.100 to .125 dia) in the PCB under
the
> center of the part and apply the stuff after all assy is complete.
>
> The adhesive properties are not important, in fact less is better. The
stuff
> should be viscous enough to fill the area under the part, but not run. It
> should be able to room temp cure in a reasonable time (2 hours or less) and
> not bloom out onto the plastic body of the part.
>
> Does anyone out there know of such a thing?
>
> Thanks, in advance
>
> Jim Ennis
> [log in to unmask]
>
> ***************************************************************************
> * TechNet mail list is provided as a service by IPC using SmartList v3.05 *
> ***************************************************************************
> * To unsubscribe from this list at any time, send a message to: *
> * [log in to unmask] with <subject: unsubscribe> and no text. *
> ***************************************************************************
>
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
|
|
|