Received: |
by ipc.org (Smail3.1.28.1 #2)
id m0vFttR-0000QuC; Tue, 22 Oct 96 22:22 CDT |
Old-Return-Path: |
|
Date: |
Tue, 22 Oct 1996 23:16:51 -0400 |
Precedence: |
list |
Resent-From: |
|
Resent-Sender: |
|
X-Status: |
|
Status: |
O |
X-Mailing-List: |
|
From [log in to unmask] Wed Oct 23 15: |
49:33 1996 |
TO: |
|
Return-Path: |
<TechNet-request> |
Resent-Message-ID: |
<"jGNOO.0.5_A.WzORo"@ipc> |
Subject: |
|
From: |
|
X-Loop: |
|
Message-ID: |
|
Parts/Attachments: |
|
|
Frank,
Don't do it!
FR2 and SMT are not a good mix.
I only use FR2 on small thru hole PCBs.
I fear you will have serious yeild problems that would cost considerably more
than FR4 will. FR2 will warp considerably and cause component level problems
after reflow.
FNKEC
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
|
|
|