Dear Tech Netters,

  We have recently purchased a new in-line cleaner. In the past, everything
  was batch cleaned.
  We had a lot of manual labor invloved with peelable mask, "popcicle
  stick" spacers to keep
  about a dozen small daughter boards from leaning over and shorting out
  against other parts, etc.

  I am looking for source(s) for:

  1. Water soluble spacers to go through the the top side of the wave
  soldering process.
  They have to be compatible with a closed loop D. I. system.   or
  2. Reusable, one piece, fixtures to replace the "popcicle stick" spacers.
  and
  3. Reusable fixtures to prevent the hold-down belt from snagging parts on
  the boards.

  Any information would be appreciated.

  Thanks in advance.

  Charles Barker
  Manufacturing Engineer
  [log in to unmask]
  713/276-3328 or 281/552-3328 (This is supposed to be the new number.)


***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to:           *
* [log in to unmask] with <subject: unsubscribe> and no text.        *
***************************************************************************