Received: |
by ipc.org (Smail3.1.28.1 #2)
id m0vCvrf-0000QPC; Mon, 14 Oct 96 17:52 CDT |
Old-Return-Path: |
|
Date: |
Mon, 14 Oct 96 13:39:31 PST |
Precedence: |
list |
Resent-From: |
|
Resent-Sender: |
|
X-Status: |
|
Status: |
O |
X-Mailing-List: |
|
TO: |
|
From [log in to unmask] Tue Oct 15 08: |
45:41 1996 |
Return-Path: |
<TechNet-request> |
Resent-Message-ID: |
<"Uipw91.0.viK.HGiOo"@ipc> |
Subject: |
|
From: |
|
X-Loop: |
|
Message-Id: |
|
Parts/Attachments: |
|
|
You need to specify what holes to be plugged so they do not plug your
holes that you used for electrical test. You can do this by a hole
size or a via pad size.
______________________________ Reply Separator _________________________________
Subject: PLUGGED VIAS
Author: [log in to unmask] at corp
Date: 10/14/96 10:24 AM
I have run into a problem with a board that has vias in smt pads. We
need all of the vias plugged, and I am told that solder mask is the best
way to do that. This is to ensure that a good vacuum is maintained for
our ATE equipment. That is the problem. I can not have a via covered
with solder mask on top of an smt pad. The board house I am using says
this is difficult for them because they have to determine which vias are
plugged and which are not. Anyone out there with any suggestions?
Thanks,
Barry Darnell
(864)627-8800 Ext. 231
[log in to unmask]
CD Electronics, Inc.
Printed Circuit Board Designer
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
|
|
|