Mime-Version: |
1.0 |
Content-Type: |
text/plain; charset="us-ascii" |
Old-Return-Path: |
|
Date: |
Wed, 21 Aug 1996 16:51:06 -0500 |
Precedence: |
list |
Resent-From: |
|
From [log in to unmask] Thu Aug 22 06: |
13:41 1996 |
X-Status: |
|
Status: |
O |
X-Mailing-List: |
|
X-Sender: |
|
TO: |
|
Return-Path: |
<TechNet-request> |
X-Loop: |
|
Resent-Message-ID: |
<"8QUWV1.0.R-A.6Cu6o"@ipc> |
Subject: |
|
From: |
|
Received: |
by ipc.org (Smail3.1.28.1 #2)
id m0utL3n-0000MlC; Wed, 21 Aug 96 16:43 CDT |
Cc: |
|
Resent-Sender: |
|
Message-Id: |
<v02130502ae413184d718@[157.175.110.24]> |
Parts/Attachments: |
|
|
William Maugans asked:
>I am experienceing a fine dusting of nodgles that show up anywhere on the
>circuits especially on ground plane areas. The nodgle is dome shaped, higher
>than the surrounding area and very spherical in shape. Bright acid copper,
>everything in spec.I have eliminated deburr, resist (as I see it on panel
>plate also only with much less frequency of occurance).Not a pit from air
>inpengment a dome. Suspect a fungus in the brightener ???
I'm not a circuit board fab person, but I know this:
Those nasty things are spelled "nodule".
You will see them in the PTH's sporadically, they are sites for entrapment
of plating liquid; when you do see nodular plating, the boards will have
lots of blow holes after the wavesolder process in assembly.
I would reject them if you shipped them to me.
The following is speculation:
You have some dust, glass fibers, or other drill imperfections which become
a copper spike after electroless Cu. The protrusion from the hole wall is a
high current site during first copper. This transforms into a spherical
hunk of copper.
If you do not have a very smooth, clean hole wall after drilling, you are
risking nodular plating. I would also guess you that your plating current
may be too high. Filter your bath for suspended solids.
cheers,
Jerry Cupples
Interphase Corporation
Dallas, TX USA
p.s. I am often wrong, but a better than average speller.
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
|
|
|