Received: |
by ipc.org (Smail3.1.28.1 #2)
id m0urPuk-0000KoC; Fri, 16 Aug 96 09:30 CDT |
Content-Type: |
text/plain; charset=us-ascii |
CC: |
|
References: |
<H00004850061c68d@MHS> |
Date: |
Fri, 16 Aug 1996 08:53:59 -0700 |
Precedence: |
list |
Resent-From: |
|
Message-ID: |
|
MIME-Version: |
1.0 |
Status: |
O |
X-Mailing-List: |
|
TO: |
|
Return-Path: |
<TechNet-request> |
X-Status: |
|
X-Loop: |
|
From [log in to unmask] Fri Aug 16 16: |
15:25 1996 |
Content-Transfer-Encoding: |
7bit |
Resent-Message-ID: |
<"Mjt3p3.0.eAM.uN85o"@ipc> |
Subject: |
|
From: |
|
Old-Return-Path: |
|
Resent-Sender: |
|
Organization: |
RAMP Inc |
X-Mailer: |
Mozilla 2.01KIT (Win16; U) |
Parts/Attachments: |
|
|
[log in to unmask] wrote:
>
> Technetters,
>
> I'm just curious about the affect on component solderability after used
> a bend&cut machine. I suspect some kind of lubricant coating after using
> these machines on our components. The machines need this to operate
> properly.
>
> Is there any other kind of lubricant or some other solution to this?
>
> How does oil affect the solderability?
>
> Is there any low-cost way to remove this oil before wave soldering
> without much time loss?
>
> I'm greatful for anykind of info.
>
> /Jan Merstrand
> [log in to unmask]
>
>
> ***************************************************************************
> * TechNet mail list is provided as a service by IPC using SmartList v3.05 *
> ***************************************************************************
> * To unsubscribe from this list at any time, send a message to: *
> * [log in to unmask] with <subject: unsubscribe> and no text. *
> ***************************************************************************
Jan, what kind of oil is being used? Yes organic contaminants affect
soldering. The type of flux being used in wave solder is also a factor.
Depending upon the oil used in cutting machine, you may wash the
components (if they are wettable) in alcohol+water and air dry prior to
insertion. Make a run on wave machine with and without cleaned component
to see the affect on soldering. Aggressive flux may not require extra
cleaning. I will be interested to know your results. Good Luck.
--
Pratap Singh
Tel./Fax: 512-255-6820
e-mail: [log in to unmask]
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
|
|
|